Fixed a bug where the Minimum Layer Time was incorrectly interpolated.Fixed a bug where the printjob name was hard to read in darkmode.Fixed a bug where ESun PLA+ would display unsupported.Fixed a bug where the message for a new Beta version available would show up during the Beta.Fixed a bug where an error would be shown too often in One At A Time print sequence.Fixed a bug where models would overlap if multiple models were loaded at the same time.Fixed a bug where models dropped to the buildplate when they were supposed to be floating.Fixed a bug where the brim line would not be printed in the same orientation.Upgraded PyQt to version 6.4.2 which improves responsiveness in the UI.Removed the settings related to Wire Printing since it was broken and barely used.Improved behavior for opening and closing categories when adding a new printer.Improved printing order of the prime tower to include a dual brim, primed every layer, and primed before and after the extruder switch.Improved accuracy of when the M104 Hotend Temperature command is added.Improved the minimum layer time for printers with multiple extruders.Introduced Skirt Height setting to make a skirt easier to remove.Introduced Hole Horizontal Expansion Max Diameter so only the expansion of smaller holes can be tuned while leaving larger holes untouched.Added support for the updated mainboard revisions of UltiMaker S3, S5, and S7.Updated the UltiMaker logo to reflect the new company logo.Try it for yourself with this Cura Cookie Cutter. Introduced the Smart Brim setting that changes the order in which the brim lines are printed making them easier to remove. Fixed a bug where the Support Interface was not correctly generated with Tree SupportĬhanged the order in which the brim is printed so it's easier to remove.Fixed a bug where the Support Overhang Angle caused a crash with Tree Support.Fixed a bug where branches were not generated when Support Interface was enabled.Fixed a bug where slicing would fail if Preference was set to On Any Flat Surface.Fixed a bug where Tree Support would generate unsupported islands.Updated options for Tree Support Rest Preference to be more correct.Introduced 10 new settings and updated 2 so anyone can tune the behavior. Introduced the new Tree Support contributed by it for yourself with this dragon pencil cup.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |